Serial¶
In this panel, users must configure the parameters of the different serial ports, Veronte LOS, RS485 and RS232, in their corresponding tab.
However, as the parameters to be configured are shared across all serial ports, they are explained here:
Baudrate: This specifies how fast data is sent over a serial line.
Length: This defines the number of data bits in each character: 4 to 8 bits.
Stop: Number of stop bits sent at the end of every character: 1, 1.5, 2.
Parity: Is a method of detecting errors in transmission. When parity is used with a serial port, an extra data bit is sent with each data character, arranged so that the number of 1 bits in each character, including the parity bit. Disabled, odd or even.
Note
All these settings are already specified for a given device, therefore, Autopilot 1x should match with them in order to be able to communicate.
Veronte LOS¶
In this panel, the serial port that communicates from the microcontroller to the internal radio is configured.
Warning
If the user changes the baudrate on the internal radio, it is also required to change it here and vice versa.
RS485/RS232¶
Two serial interfaces are available with Autopilot 1x, 1 port RS-232 and 1 port RS-485, however more can be added by using a CEX or MEX. Each one of the serial interfaces is associated with a set of pins.
Compatibility table:
Port name |
RS-232 |
RS-485 |
|
---|---|---|---|
RS-422 |
RS-485 |
||
Transfer type |
Full duplex |
Full duplex |
Half Full duplex |
Maximum distance |
15 meters at 9600 bps |
1200 meters at 9600 bps |
|
Topology |
Point to point |
Point to point |
Multi point |
Max number of devices |
1 |
1-10 in receive mode |
32 |